5.2.3　Vertical correction factor

　

where

H_TC is the vertical extent of the slamming pressure, in metres;

H_TC is be measured according to figure 9, in metres;

h is the height above the bottom/side intersection to center of plate or structural member, in metres;

z is the height above base line to the bottom/side intersection at the longitudianal position under consideration, in metres.

Figure 9 - Side pressure distribution factor κ_v

　

5.2.4　Design pressures

　

5.2.4.1　Motor craft, side pressure

P_s1 =[f_w2・(H_TC・10)+(0,2・P_b1base)]・k_ar・k_L・k_v kN/m² (12)

P_s1min = [ 0,278・L_wL+ 4,33]f_w2 kN/m²

前ページ　　　目次へ　　　次ページ